CNC machined reverse and trim levers on a single axis
Built to the highest of quility possible!
Our universal controller accepts 40 series cables with 100mm or 75mm of travel in either push or pull configuration for the reverse bucket, which means its ideal for jetski setups and other smaller travel reverse configurations.
Accepts 30 series cable for trim with 75mm of travel.
Over centre locking reverse
Push or pull configuration
Adjustable reverse lever angle in 10degree increments
Zero friction on reverse lever (on 2x Deep Groove Ball Bearings)
Adjustable trim friction via allan key with access through front cover.
100mm / 4 inches of travel is achieved in 135degrees including the over centering stop.
Reverse Lever/handle length: 220mm / 8.5 inches
Trim lever/handle length: 110mm / 4.3 inches
CNC machined reverse and trim levers on a single axis
Built to the highest of quility possible!
Our universal controller accepts 40 series cables with 100mm or 75mm of travel in either push or pull configuration for the reverse bucket, which means its ideal for jetski setups and other smaller travel reverse configurations.
Accepts 30 series cable for trim with 75mm of travel.
Over centre locking reverse
Push or pull configuration
Adjustable reverse lever angle in 10degree increments
Zero friction on reverse lever (on 2x Deep Groove Ball Bearings)
Adjustable trim friction via allan key with access through front cover.
100mm / 4 inches of travel is achieved in 135degrees including the over centering stop.
Reverse Lever/handle length: 220mm / 8.5 inches
Trim lever/handle length: 110mm / 4.3 inches
